How to Install the MW Series Antenna Kit
This video provides step-by-step instructions for installing the MedixSafe RFID Antenna Kit on an MW safe.
The video walks through replacing the existing cover, installing RF filtering components, connecting the RFID cables, and securing the new cover.
What You’ll Learn
After watching the video, you will know how to:
- Authenticate and open the MW Safe using the reader or key override
- Remove the existing cover and disconnect its wires
- Install the required RF filters and chokes
- Prepare the new RFID-ready cover
- Connect the RFID cables to the PCB
- Reassemble the safe and secure the new cover
Before You Begin
Have the RFID-ready cover and required RF filtering components available. Follow the sequence shown in the video, taking care when disconnecting and reconnecting wires. Position cables so they are not pinched or damaged when the new cover is secured.
Installation Video Chapters
| Time | Chapter |
|---|---|
| 0:00 | Introduction to MW cover replacement |
| 0:21 | Authenticating and opening the safe |
| 0:40 | Removing the cover screws |
| 1:06 | Detaching the cover and disconnecting wires |
| 1:48 | Installing RF filtering components |
| 3:08 | Preparing the new cover for installation |
| 4:37 | Connecting RFID cables to the PCB |
| 5:59 | Securing the new cover |
| 7:08 | Finalizing the installation |
Verify the Installation
After securing the new cover, follow the final steps shown in the video. Confirm that the cover is properly fastened, the safe opens and closes normally, and the connected cables are not pinched.
Need Help?
If you encounter an issue during installation or the safe does not operate as expected, contact MedixSafe Technical Support.